Operation - Cub Cadet D20 Bedienungsanleitung

Operation

After the charging process, remove the connec-
230-V socket and then from the charging socket of
the device.
Note
On the LCD display
symbol and the
and the percentage of the charge is dis-
played at the same time. The power pack
is fully charged when the indicator shows
100%.
automatically switches to rest mode after
out.
If you obtain an error message at any time while
charging, please proceed as follows:
Disconnect the charger from the power source
Disconnect the charger from the charging socket
on the device .
Connect the charger to the power source again
Connect the charger to the charging socket on the
device again .
If the problem persists, refer to a service centre.
Further instructions
—
charging the power pack to about 50% of
the maximum charge is recommended.
—
230-V socket and then from the charging
— Fully charging the power pack after each
instance of use is recommended. Storing
power packs in a discharged state could
impair the future capacity of the power
pack.
—
soon as the power pack is fully charged.
—
discharged prior to charging.
—
charged state for long periods. The power
pack could be permanently damaged.
[A]
.
.
-
-
-
Check tyre pressure
Note
be higher than required.
Check the tyre pressure and correct it where
necessary.
Front 0.9 bar
Rear 0.7 bar
Adjusting the driver's seat
Pull the lever and adjust the seat
or
Release the adjusting screw, set the seat and
tighten the adjusting screw once again
Adjusting the cutting mechanism wheels
The cutter wheels should never be lower than
6–12 mm above the ground at the lowest cutter
position. The cutter wheels are not designed to bear
the loads generated by the cutters and may have
Always move the cutting wheels so they line up
evenly.
Operation
WARNING!
Risk of injury
Never leave the driver's seat during
operation
-
- without actuating the brake pedal and
engaging the parking brake.
- engage the parking brake
-
safety key.
Note
Comply with the national/municipal regula-
authority).
EN
.
.
19