Servicing - Cub Cadet D20 Bedienungsanleitung

Operation
USB ports (model-specific)
Attention!
When starting the tractor, no other devices may
be connected to the USB ports because this can
lead to damage to the connected devices.
The two USB ports [A] are located on the left side
of the device near the control module. The two USB
ports are each provided with a charge current of
2.1 A. You can charge your phone or run other USB
devices through the two ports, for example.
WARNING!
Risk of injuries or material damage
Perform all servicing and cleaning work
Pull out the safety key.
Wait until all moving parts have come to
a complete stop.
Wait until the device has cooled down
(approx. 15 minutes).
Never reach into the rotating cutter
blades.
Only have repair and maintenance work
and the replacement of safety compo-
or a specialist service centre.
Only have the cutter blades replaced
or re-sharpened by a specialist service
centre.
Have all work on the cutter deck – such
as disassembly and assembly – per-
formed by a service centre only.
Clean the device and all attachment and
accessory parts after every instance
of use. Collections of very dry dirt and
mowing residues can present a risk of
Have all work on the power pack,
charger or the electrics performed by a
service centre only.
Have all maintenance work performed to
(reaching the relevant number of operat-
ing hours).
Parking the device
Stop the device.
Bring the cutter deck to the top position.
Switch the parking brake on.
Pushing the device
Only push the device slowly by hand with the safety
Note

Servicing

Cleaning the device
Risk of property damage.
Do not use water to clean the tractor, the
power pack or the charger.
household detergents or other solvents
because they could damage the plastic
parts on the device.
Switch the parking brake on.
Clean the device with a scrubbing brush, hand
brush or a cloth.
Note
Make sure that no dirt accumulates around
tions.
instance of use.
WARNING!
EN
-
23