Cub Cadet D20 Bedienungsanleitung Seite 24

EN
Cleaning the cutter deck
DANGER!
Sharp, moving cutting tools
Risk of injury
Wear protective gloves.
Clean the cutting tools carefully.
Bring the cutter deck to the top position.
Clean the cutting chamber with a scrubbing brush,
hand brush or a cloth.
Bring the cutter deck to the top position.
Clean the top of the cutter deck carefully with a
scrubbing brush, hand brush or a cloth.
Cleaning the drive motor / rear axle
gearbox with a scrubbing brush, hand brush or a
cloth.
Servicing the device
At the end of the season, have the device in-
spected and serviced by a service centre.
Note
installed Li-Ion power pack.
Tyre pressure
WARNING!
Increased tyre pressure
Risk of accident and damage to the
device
Never exceed the permitted tyre pres-
sure (see tyre wall).
Check the tyre pressure and correct it where
necessary.
Front 0.9 bar
Rear 0.7 bar
Note
life of the tyres. Check tyre pressure prior to
each journey.
After 5 operating hours (S01)
– tightening torque 52–68 Nm.
24
Every 5 operating hours (SO2)
Check the tyre pressure.
Every 10 operating hours (SO3)
Lubricate all rotating and bearing points of the
accelerator pedal, brake pedal and cutting height
adjustment lever with a few drops of light oil.
Every 25 operating hours (SO4)
Lubricate the teeth of the steering gear and the
steering rack with multi-purpose grease.
Lubricate the wheel bearings and front wheel
axles at the lubricating nozzles using a multi-pur-
pose grease.
Have the cutter deck checked to make sure it is
set correctly.
Note
Excess lubrication can become accumula-
Every 50 operating hours (S05)
Every 100 operating hours (S06)
Check that all screw connections and attachment
Note
in the form of a symbol on the LCD display
Example:
!
S02
ery 5 operating hours must be performed.
"S01 to S06" behind the tool key represents
the corresponding number of operating
hours.
display can be deleted by pressing the
cruise control switch.
Operation
-
-