Removing The Oven Door; Telescopic Pull-Out Rails; Changing The Oven Light Bulb - KKT KOLBE EB8013ED Benutzerhandbuch

Care and cleaning

Removing the oven door

• Fold down the oven door in the horizontal position and
lift the brackets on the two door hinges to the front
• Slowly close the oven door until it stops. Then lift the door
until the hinges disengage.
• The insertion is carried out in reverse order.
At last, swing the brackets back to the hinge supports.
Removint the slide in racks
• Remove accessories such as rust and baking sheet.
• Push down the rack slightly at the clamping point (1) and
pull it away from the oven wall.
• Swing the rack inwards and unhook it at the top (2).
Inserting the slide in racks
• Hängen Sie das Gitter oben in die Löcher ein und schwen-
ken Sie es nach unten.
• Drücken Sie den Gitterstab an der Klemmstelle etwas nach
unten und drücken Sie ihn zur Seitenwand hin.
• Das Einhängegitter muss einschrasten und fest sitzen.

Telescopic pull-out rails

The telescopic pull-out rails can also be removed for easier
cleaning.
• Use a large screwdriver to loosen the lower fastening
screws and remove the complete set.
• Do not immerse the telescopic pull-out rails in water and
do not clean them in the dishwasher, but clean only the
outside with commercially available cleaning agents.
Note: The rollers must not be greased.
!
After cleaning, hook in the telescopic pull-out
rails and fasten them again at the bottom with the
screws.
50
Hinge support

Changing the oven light bulb

In the lamp bulb is a particularly heat-resistant mold
(230 V, 25 W)..
To replace this, proceed as follows:
• Disconnect in any case the device from the power
supply (pull the plug or remove the fuse), because the
wording could be live.
• Turn out the glass and replace it with a new of the same
type (see figure at right).
• Screw back the cover glass.
Clip
2
1