Care And Cleaning; Case Front; Oven Interior; Steamclean Method - KKT KOLBE BO8810SS Benutzerhandbuch

Care and cleaning

Care and cleaning
!
• For cleaning, don't use steam cleaners.
• Before cleaning the machine, let it cool down and un-
plug from the mains.
• Don't use abrasive cleaning agents, abrasive scourers
or sharp objects.

Case front

• Only use commercially available agents according to the
manufacturer's instructions for cleaning and maintenance
of the front surfaces.
• Stainless steel surfaces can be cleaned and wiped dry with
mild detergents (eg soap) and a soft cloth.
• Aggressive cleaning agents (eg vinegar-based cleaners),
abrasives, abrasive grit and sharp objects will damage the
surface of the appliance!
Hinge support
46
Clip

Oven interior

• Der Garraum lässt sich leichter reinigen, wenn er noch
handwarm ist.
• Remove simple grease splashes with rinse water.
• Use conventional oven cleaner for stubborn or severe
soiling. Rinse thoroughly with cold water to remove all
cleaning agents are removed completely.
• When using oven sprays, observe the manufacturer's
instructions. Painted, anodized, galvanized surfaces, alu-
minum parts and radiators may not come in contact due to
possible damage and discoloration with these sprays.
• Clean the accessories such as baking tray, drip pan, grate,
etc. with hot water and a little detergent.

SteamClean method

This function facilitates the oven cleaning essentially, be-
cause the dirt can be solved more easily by water vapor and
heat.
• Remove any accessories such as roasting pan, baking sheet
and rust.
• Pour down about 0.4 liters of water with a little detergent
into the trough of the soil.
• Close the oven door. Select bottom heat heating at 50 °C.
• Switch off the appliance after about 30 minutes and discon-
nect the power. Remove soaked food debris with a cloth.
• For baked-on soils, note the previous cleaning instructions.

Removing the oven door

• Fold down the oven door to the horizontal position.
• Lift the bracket on the two door hinges to the front.
• Slowly close the oven door until it stops.
Then lift the door until the hinges disengage.
• The insertion is carried out in reverse order.
At last, swing the lever back to the hinge support.