ATH-Heinl ATH Cross Lift 40 Bedienungsanleitung Seite 92

d) If an axis measuring turntable is used, it can be adjusted by means of the screw underneath (optional).
9. Installation of the limit switches
a) Raise the lift to the maximum height (see
b)
Mount the limit switch
the position
c) Perform a functional test of the limit switch
d) Lower the lift to a height of 400 mm above the floor.
e)
Mount the CE stop
® Copyright ATH-Heinl GmbH & Co. KG / All rights reserved / Misprints and technical changes reserved
92
"Technical
to the angle and adjust it by means of attached nuts so that it is activated in
on the scissors and adjust the cut-off arm so that it is activated in position
Release date: 05.04.2023 / Product manufacturer ATH-Heinl GmbH & Co. KG
data").