ATH-Heinl ATH Cross Lift 40 Bedienungsanleitung Seite 103

Problems during lowering
Symptoms
Lift does not lower
Platform lowers too slowly or
jerkily
Lift lowers by itself
Other problems
Symptoms
Lift does not raise and lower
synchronously
Product shows (severe) rust
damage
Unusual loudness of the motor
® Copyright ATH-Heinl GmbH & Co. KG / All rights reserved / Misprints and technical changes reserved
Cause
Safety catches do not react
Defective control relay
Obstacle under platform
Hose rupture protection triggered
Lowering valve is not activated
Solenoid coil of lowering valve
defective
Lowering valve defective
Valve for lowering speed
incorrectly adjusted
If the errors cannot be rectified, lower the lift using the
emergency lowering screw and contact our service team.
Lowering valve dirty
Valve for lowering speed
incorrectly adjusted
Leaky hydraulic connections
Leaky hydraulic lines
Leaky hydraulic cylinder
Dirty or defective lowering valve
Leaky check valve
Cause
Air in hydraulic circuit
Insufficient tension of the
synchronous ropes
Damage or insufficient corrosion
protection Maintenance if
necessary
Oil filter contaminated
Air in hydraulic circuit
Dirty hydraulic oil
Release date: 05.04.2023 / Product manufacturer ATH-Heinl GmbH & Co. KG
Solution
Check cable connection Check
electromagnets, replace if
necessary Relieve safety notches by
lifting
Check control relay
Remove obstacle
Raise platform briefly and press
"DOWN" again
Check electrical connection
Replace solenoid coil
Exchange
Adjust
Clean lowering valve
Adjust
Tighten connections and seal if
necessary
Replace hydraulic line
Replace seals and clean hydraulic
system
Clean or replace the lowering valve
Clean or replace
Solution
Bleed hydraulic circuit
Adjustment of the voltage or
synchronization
Remove rust, clean and restore
surface.
Clean oil filter
Bleed the hydraulic system
Replace the hydraulic oil
103