Motor; Display - FitNord Flow Benutzerhandbuch

4.3 Motor

Your bicycle's powerful TechDrive motor ensures functional, powerful and quiet ope-
ration. The motor produces a torque of up to 55 Nm with a power of 250 W, and it
offers a lot of assistance on both flat terrains and uphill. Its assistance options ensure
that you will find a suitable level of assistance for any situation.

4.4 Display

Due to the TechDrive control panel, the electric system under your full control. Its
simple settings allow you to obtain all the necessary details of your electric bicycle at
the press of a button so you can focus on the actual riding. The functions and further
features of the display have been explained on the following page.
The display operates together with the sensor located in the crank arm set, which
stops the motor when the rider stops pedalling. The bicycle can also be used without
the motor's electric assistance when the level of assistance has been set to 0. An
empty battery does not prevent the bicycle from being used. It is recommended that
the assistance system is disabled slightly before the battery is completely empty be-
cause using the battery until it is fully empty shortens the service life of the battery's
cells.
Assist + / Lights when held
(Not with lighting with
separate battery source)
Power on / Shown info
Power off when held
Assist - / Walk assist
when held
Display buttons
The display has three buttons: M + and –.
M is the mode selection button and the power button (MODE/ON/OFF). + button
allows you to move UP, and while riding the
bicycle, it increases the level of assistance. If the + button is held down, the button
also operates as the ON/ OFF switch for the lights – operates as a DOWN button,
and while riding the bicycle, it decreases the level of assistance. When held down, the
– button also operates as an operating switch of the walking assist feature (6kmh).
Battery and motor
power level
Assist level
Speed
Info
EN
45