ZAPTEC Pro Bedienungsanleitung Seite 13

Colour
NO LIGHT
PURPLE
GREEN
BLUE
RED
Serial number
e.g. ZPR123456
Meaning
Charging station has not been activated in the Zaptec
Portal, no power from the power circuit, incorrect
connection or product fault. Check the serial protection in
the distribution cabinet.
Not updated during charging.
• Check that the charging cable has been inserted into the
charging station correctly.
• Check that the vehicle has been configured to start
charging immediately.
• Communication is taking place between the charging
station and the vehicle.
• Check whether the vehicle is configured to start charging
immediately.
Flashing red light
• Authentication failed – Check that the RFID tag/charging
card is connected to your user profile.
• Authentication failed – Check in the Zaptec Portal that
your user has access to charge on the charging station
and/or installation concerned.
Steady red light
• Disconnect the charging cable. If the status indicator
illuminates green, you can connect the charging cable
again. If charging does not start and the indicator
illuminates red again, there may be a charging fault on
the charging cable or vehicle.
• If the status indicator lamp does not turn green after the
charging cable has been disconnected, you must check
the fuses as described in the chapter 'Checking the fuses
in the charging station'.
• Authentication failed – Check that the RFID tag/charging
card is connected to your user profile.
If the charging station has been
disconnected from the power network,
it will take 2–3 minutes before the
charging station starts up again.
English
13