Transportation, Storage, Unpacking - flamco NFE-MVE Montage- Und Serviceanleitung

4.6 Transportation, storage, unpacking

If packages are suitable for transportation by lifting means, they have markings for the attachment
points required.
Important note: Transport the packed scope of supply as close as possible to the intended place of
installation and use a horizontal surface area with load-bearing ground.
Attention: Actions and measures are required to prevent any uncontrolled dropping, sliding and
tilting of loads. Intermediate storage can also be effected in a packaged condition. Stacking of the
packaged equipment is permissible up to a maximum of four packaging units on top of one another.
Any stacking beyond this limit is to be prevented. Use only approved load-handling equipment,
safe tools and wear the necessary protective equipment.
8
Manual NFE-MVE
The equipment is supplied in packaging units
that correspond to the model in accordance with
the order or the requirements of the transport
route and climatic zone. They meet at least the
requirements of the packaging guidelines of the
manufacturer. In compliance with this guideline
the replenishment equipment/modules are
supplied in cardboard boxes lying in a horizontal
position on special pallets or Euro pallets. The
pallets are suitable for transportation by means
of approved forklift devices. To do this, set the
largest possible fork external dimensions for the
pallet to prevent any tilting over of the load taken
up. Move the delivery item in the lowest possible
position and across the fork pairs.