Stand-Alone Operation - EuroLite LED TMH-B60 Bedienungsanleitung

Stand-alone operation

Addr / DMX address setting
With this function, you can adjust the desired DMX address via the Control Board.
CHnd / DMX channel mode
With this function, you can select the desired DMX channel mode.
SLnd / Master / Slave setting
With this function, you can define the device as master or slave. You can choose one of two different Slave
settings.
SL 1 = Synchronous movement, SL 2 = Asynchronous movement
SHnd / auto program
Auto mode (SH0 – SH3)
With this function, you can run 4 different internal programs.
Soud / music control
With this function, you can call up and run the internal program sound-controlled.
SEnS / Mic sensitivity
With this function, you can select the desired microphone sensitivity between 0 % and 100 %.
blnd / no DMX status
With this function, you can set different modes if there is no DMX-signal.
LEd / Display turn off
With this function, you can shut off the display: ON the display stays lit; OFF the display turns off after 10
seconds.
dISP / display reverse
With this function, you can flip the display by 180° for a better view when the fixture is hung from a truss or a
ceiling.
rPAN / Invert PAN
With this function, you can reverse the PAN-movement.
rTIL / Invert TILT
With this function, you can reverse the TILT-movement.
rESt / Reset
With this function you can reset the device via the Control Board.
24/28 127079.docx, Version 1.0