Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connection to the mains
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1
Connect the device via the enclosed mains cable to a grounded mains socket.
2
Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.
POWER IN
POWER IN
DMX IN
DMX IN
DMX OUT
DMX OUT
100-240V ~
100-240V ~
POWER OUT
POWER OUT
50/60 Hz
50/60 Hz
Power supply of further devices
The jack POWER OUT allows for power supply of further devices. To interconnect several devices, connect
the jack POWER OUT to the input POWER IN of the next unit until all units are connected. Matching power
cables with P-Con plugs are available as accessories. In this manner, up to 8 devices can be linked at
230/240 input voltage and up to 4 devices at 110/115 input voltage.
OPERATION
With the power switch, you can switch the device on and off. After you connected the effect to the mains, the
device starts running. During the Reset, the motors are trimmed and the device is ready for use afterwards.
The operating modes can be selected by means of the display and the control buttons. All settings remain
stored even if the device is disconnected from the mains.
The device has two operating modes. It can be operated in stand-alone mode via the control board or in
DMX-controlled mode via any commercial DMX controller and wireless via QuickDMX with the optional
available EUROLITE QuickDMX USB Wireless Transmitter/Receiver.
Stand-alone operation
In stand-alone mode, the LED TMH-S180 can be used without controller. Disconnect the LED TMH-S180
from the controller and call up the internal program. Please refer to the instructions under Control Board.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT-jack with the DMX IN-plug of the next device.
Set the master device to the desired run mode "Auto1", "Auto2", "Auto3", "Auto4", "Random" or "Sound". Set
all slave devices to the mode "DMX". Please refer to the instructions under Control Board.
OFF
OFF
ON
ON
T3.15A/250V
T3.15A/250V
DMX IN
DMX IN
DMX OUT
DMX OUT
OFF
OFF
ON
ON
POWER IN
POWER IN
100-240V ~
100-240V ~
POWER OUT
POWER OUT
T3.15A/250V
T3.15A/250V
50/60 Hz
50/60 Hz
28/36
OFF
OFF
ON
ON
POWER IN
POWER IN
DMX IN
DMX IN
DMX OUT
DMX OUT
100-240V ~
100-240V ~
POWER OUT
POWER OUT
T3.15A/250V
T3.15A/250V
50/60 Hz
50/60 Hz
00138072, Version 1.0
Werbung
Inhaltsverzeichnis
