Master/Slave Operation; Connection To The Mains; Operation; Stand-Alone Operation - EuroLite LED TMH-51 Bedienungsanleitung

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
To set the Master/Slave mode, press the MODE button and select Slnd.
Set the master device to MASTER mode. You can now set the desired internal program or sound control.
To set the slave device, press the MODE button and choose SLAVE 1 or SLAVE 2. The devices set in this
manner can now be controlled by the master unit.
Please see further instructions under Control Board.

Connection to the mains

The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1 Connect the device via the enclosed mains cable to a grounded mains socket. Thus the unit is
switched on.
2 To switch off the unit, disconnect the power plug.
3 Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a
mains outlet which is switchable.

OPERATION

After you connected the effect to the mains, the LED TMH-51 Hypno Moving-Head Beam starts running.
During the Reset, the motors are trimmed and the device is ready for use afterwards.
The display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the Control Board or in
DMX-controlled mode via any commercial DMX controller.

Stand-alone operation

In the Stand-alone mode, the LED TMH-51 Hypno Moving-Head Beam can be used without controller.
Disconnect the LED TMH-51 Hypno Moving-Head Beam from the controller and call up the internal
programs. Please refer to the instructions under Control Board.
27/36 00110746, Version 1.2