Connection With The Mains; Operation; Internal Programs - EuroLite LED MAT-192 DMX Bedienungsanleitung

If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

After you connected the effect to the mains, the EUROLITE LED MAT-192 DMX starts running and the
display lights up.
This unit has two operating modes. It can be run manually or via the IR remote control.
You can choose the desired mode from five operating modes:

- INTERNAL PROGRAMS

- AUTO MODE
- DMX MODE
- SOUND CONTROL MODE
- MASTER/SLAVE MODE
INTERNAL PROGRAMS
LED Display Operation:
Press the MODE button. The display shows „PrXX". The desired program can be selected with the UP or
DOWN buttons.
-- Pr is the abbreviation of program; Pr01 stands for the internal sentences; Pr02 – Pr17 stands for the
internal light effect programs.
International
L
N
20/25
Ω
resistor
00031787.DOC, Version 1.0