Master/Slave Operation; Operation - EuroLite LED TMH-B60 Bedienungsanleitung

Master/Slave operation

Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
Slnd is indicated on the display. Confirm with the ENTER button. Use the buttons UP and DOWN to
select "SL1" or "SL2" and confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode ("Auto" or "Soun"). The interconnected devices will
now operate synchronously.

OPERATION

After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board or in DMX-controlled mode via any commercial DMX controller as well as
wireless via QuickDMX
Transmitter/Receiver.
After you connected the effect to the mains, the EUROLITE LED TMH-B60 Moving-Head Beam starts
running. During the Reset, the motors are trimmed and the device is ready for use afterwards.
with the optionally
22/28
available EUROLITE QuickDMX USB Wireless
127079.docx, Version 1.0