Dometic 10-Serie Bedienungsanleitung Seite 24

Troubleshooting
Fault
The refrigerator is not
cooling adequately.
7.1 Error and warning indication
All faults are indicated by a warning symbol, a fault ID and a beep. The beeping lasts
for 2 minutes and is repeated every 30 minutes until the error has been rectified.
RCD10.5ET, RCD10.5XET
Faults are indicated by a fault code with a warning symbol (
TFT display.
If multiple faults occur, the fault codes scroll over in the middle of the display.
All faults of the WARNING (W) type are reset automatically once the fault has been
rectified.
All faults of the ERROR (E) type must be reset manually:
➤ Press the control knob for at least 2 seconds.
✔ A beep sounds.
✔ The error has been reset.
24
Possible cause
The ventilation around the cool-
ing unit is not sufficient.
The evaporator is iced up.
The temperature is set too high.
The ambient temperature is too
high.
Too much food was placed in the
refrigerator at the same time.
Too much warm food was placed
in the refrigerator at the same
time.
The refrigerator has not been
operating for very long.
Suggested remedy
➤ Check that the ventilation grille is
not obstructed.
➤ Check whether the refrigerator
door closes properly. Make sure
that the refrigerator seal fits cor-
rectly and is not damaged. Defrost
the refrigerator.
➤ Set a lower temperature.
➤ Remove the ventilation grille for a
while so that warm air can escape
quicker.
➤ Remove some of the food.
➤ Remove the warm food and leave
it to cool down before putting it in
again.
➤ Check the temperature again after
four or five hours.
) in the middle of the
RCD10.5
EN