Joining The Fuselage; Wing Installation - Horizon Hobby HANGAR 9 Aermacchi MB-339 Bedienungsanleitung

128. Insert the stabilizer screw grommet using a small amount of
silicone adhesive.

JOINING THE FUSELAGE

129. Slide the four fuselage joining tubes into the front half of the
fuselage.
130. Prepare the five screws that secure the forward fuselage to
the rear fuselage by sliding a tapered washer on an M4 x 20
socket head cap screw.
Î A small round file may be required to slightly
enlarge the hole in the tapered washer.
131. Slide the forward fuselage into position on the rear fuselage.
They will fit tightly together.
132. Secure the fuselage section using the five screws prepared
earlier. Tighten the screws using a 3mm hex wrench.
Î Use threadlock to keep the screws from vibrating loose.
Î Check the screws periodically as the wood formers may
compress over time and result in the screws becoming loose.
EN
133. Mount the remote receiver above the fuel tank using hook
and loop tape. Connect any extensions for the flaps, ailerons,
retracts and brakes and route them back in the fuselage.
134. Place the canopy hatch in position on the fuselage.

WING INSTALLATION

135. Slide the wing tube into the socket in the wing. Do not force
the tube in farther than it will easily slide.
136. Slide the tube into the socket in the fuselage. Connect the
leads for the aileron and flap to the extensions. Guide the
leads for the retract and brake into the wing.
137. Slide the wing tight against the fuselage.
18