Horizon Hobby HANGAR 9 Aermacchi MB-339 Bedienungsanleitung Seite 15

98. Check the bend in the tubing to make sure it does not touch
the top of the tank.
99. Use a soldering iron and solder to create an area on each of
the tubes (both outside, and the unbent tube inside the tank)
so the fuel tubing can be secured to the tubes.
100. Cut a piece of fuel tubing and slide it on the clunk line for the
fuel tank. Fit the clunk and measure the length shown. Adjust
the length of the tubing to achieve the measurement.
101. Use a wire tie to secure the fuel line to the brass fuel line.
102. Use a wire tie to secure the fuel line to the clunk.
Aermacchi MB-339
103. Fit the stopper in the tank and check that the clunk can move
freely in the tank. Adjust if necessary. Secure the stopper
using the M3 x 25 socket head cap screw. Tighten the screw
using a 2.5mm hex wrench.
Î Do not overtighten the screw and damage the fuel tank.
104. Remove the hatch from the bottom of the rear fuselage and
set it aside in a safe location.
10 1 / inches (267mm)
2
105. Remove the hatch from the top of the rear fuselage and set it
aside in a safe location.
106. Mount the fuel tank tray in the fuselage from the bottom
using the four knurled screws.
107. Pass the three tie wraps around the fuel tank tray so the fuel
tank can be secured to the fuel tank tray.
15 EN