Plug-In Sequence - HBM espressoDAQ DQ401 Kurzanleitung

8

3.3.1 Plug-in sequence

1. Connect the power supply to the USB HUB and turn on the voltage
(230 V)
The green Power LED on the back of the housing must light up
Power
supply
Abb. 3.3: Connecting the power supply
2. Connect the PC and the other modules
Standard USB cable,
1-USBHUB-4A
Power
supply
Abb. 3.4: USB HUB connection with 4 modules
Following the correct connection sequence stops the USB HUB disconnecting
one or more of its channels (and thus the corresponding espressoDAQ mo-
dule) from the voltage supply, so that when this module is selected, it is not
recognized by the relevant software (such as catman
Connecting modules and transducers
1. 2.
1-KAB286-2
USB
USB
USB
USB
Starter).
[
A2887−2.0 en/de