Placing The Probe In Configuration Mode - Renishaw OLP40 Schnellstartanleitung

Placing the probe in configuration mode

2
1
LED check
> 5 s
3
3
Deflect the stylus and hold
deflected until after the battery
Key to the symbols
status has been displayed at the
end of the review sequence.
LED short flash
LED long flash
Deflect the stylus for less than 4 seconds
Battery status
to move to the next menu option.
Battery good Battery low
or
Deflect the stylus for more than 4 seconds
to move to the next menu.
To exit, leave the stylus untouched for
To change the switch on method,
more than 20 seconds.
go to the next page.
1-8