Use; Cleaning And Storage - Cleanmaxx HZ-01 Gebrauchsanleitung

USE

Please Note!
■
If the device is being used in a room
for the fi rst time, keep an eye on it
during vacuuming in case you need to
remove any obstacles.
■
Keep animals away from the device
while it is operating.
■
Do not cover up the sensors. Make
sure that they are always free and
clean.
Preparing the Room
• Remove any objects lying around on
the fl oor that could get caught in the
suction opening (13) or could impede
the device during cleaning. In particu-
lar, do not leave plastic bags lying on
the fl oor.
• Make sure that no cables, cords, or
fringes, for example from curtains,
tablecloths or rugs, are in the path
of the device. If necessary, fold the
fringed edges of rugs under the rug.
• Remove all objects that could be
tipped over (e.g. vases, small lamps,
decorations).
• The distance between two objects
(e.g. wall and shelf) must be at least
40 cm so that the device can get
through.
• The device can get stuck under furni-
ture which it can just about get under.
Block its path, for example with fl ower
pots that are heavy enough not to get
knocked over.
Inserting the Dust Container
The dust container (1) must be emptied if
necessary and reinserted BEFORE start-
ing the device (see chapter "Cleaning
and Storage").
09860_Inlay_DE-EN-FR-NL_A5_V8.indb 17 09860_Inlay_DE-EN-FR-NL_A5_V8.indb 17
Attaching the Floor Cloth
The fl oor cloth can additionally be used
to remove dust on hard fl oors more
thoroughly. It is attached to the fl oor
cloth holder (10) using the hook and loop
fasteners.
Remove the attachment for the dust cloth
if you want to use the device on carpets:
• Pull the attachment for the dust cloth
simply off.
• If you then want to secure the attach-
ment on again, fi rst place a locking
lug into the notch which is provided
and then slide the second locking
lug into the other notch with a little
pressure.
Starting the Device
1. Make sure that the device is free of
any contamination (see the "Cleaning
and Storage" chapter) and the battery
is charged up.
2. Switch on the device with the
On / Off switch (4). The robot vacuum
cleaner starts.
3. To stop the robot vacuum cleaner,
press the On / Off switch.

CLEANING AND STORAGE

Please Note!
■
No liquid must get into the device.
Never immerse the device in water!
■
Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. These may damage
the surfaces.
Before and after every use, make sure that
• the dust container has been emptied,
• the sensors (12) are clean,
• the suction opening (13) is not
clogged,
• no hairs, threads, or similar things are
wrapped around the wheels (11).
EN
17
04.01.2022 16:14:12 04.01.2022 16:14:12