Power Tool Use And Care; Service; Safety Instructions For Routers; Supplementary Notes - Parkside POF 1200 D3 Originalbetriebsanleitung

4. Power tool use and care

a) Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer at
the rate for which it was designed.
b) Do not use the power tool if the switch does
not turn it on and off. Any power tool that
cannot be controlled with the switch is
dangerous and must be repaired.
c) Disconnect the plug from the power source
and/or remove the battery pack, if detach-
able, from the power tool before making any
adjustments, changing accessories, or storing
power tools. Such preventive safety measures
reduce the risk of starting the power tool acci-
dentally.
d) Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool. Power tools are
dangerous in the hands of untrained users.
e) Maintain power tools and accessories. Check
for misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool's operation.
If damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories and accessory
tools etc. in accordance with these instruc-
tions, taking into account the working condi-
tions and the work to be performed. Use of
the power tool for operations different from
those intended could result in a hazardous
situation.
h) Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for
safe handling and control of the tool in unex-
pected situations.
POF 1200 D3

5. Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.

Safety instructions for routers

a) Always hold the appliance using the insulated
handle surfaces since the milling cutter can
damage its own power cord.
Contact with a live wire may make exposed
metal parts of the power tool live and could
give the operator an electric shock.
b) Fix and secure the workpiece to a stable base
using clamps or other methods. If you only
hold the workpiece in your hands or against
your body it will remain unstable, and this can
result in loss of control.
■ Wear a dust mask.

Supplementary notes

■
The maximum speed of the milling tool used
must be at least as high as the maximum
speed specified for the power tool. Accesso-
ries which rotate faster than the maximum
permissible rate can be destroyed.
■
Cutters or other accessories must fit exactly
into the collet chuck (shank diameter 6/8 mm)
of your power tool. Milling tools which do not
fit precisely into the collet chuck of the power
tool will rotate unevenly, vibrate severely and
can lead to a loss of control.
■ Always switch on the electrical power tool
before applying it to the workpiece. Other-
wise, there is a risk of a kickback if the acces-
sory tool gets caught in the workpiece.
■ Keep your hands clear of the milling area and
the milling tool. Hold the auxiliary handle or
motor housing with your other hand. If both
hands are being used to hold the milling machine,
neither can be injured by the milling cutter.
GB │ IE │ 5 ■