Re-Adjusting The Milling Depth; Setting The Milling Depth With The Step Stop; Milling Direction - Parkside POF 1200 D3 Originalbetriebsanleitung

Re-adjusting the milling depth

♦ The milling depth can be readjusted using the
dial .
♦ Release the clamping lever
wise and pushing the appliance downwards
until the depth stop
reached.
♦ Lock the clamping lever
clockwise.
♦ Undo the locking screw
adjust the milling depth adjustment scale
that you can set the exact zero point, for
example. Retighten the locking screw
♦ Release the clamping lever
clockwise and raise the appliance again. Check
the milling depth by means of another practical
test.
Setting the milling depth with the
step stop
NOTE
► The step stop can be used for greater
milling depths in several stages with less chip
removal.
♦ Set the desired milling depth to the lowest step
(0 mm) of the step stop
above).
♦ Then set the higher levels for the first machining
steps.
♦ Check the milling depth by means of a practical
test.
■ 8 │ GB │ IE
by turning it clock-
on the step stop is
by turning it anti-
. Use the dial to
so
.
by turning it
(as described

Milling direction

The milling process must always be carried out
against the direction of rotation of the milling cutter
(reverse rotation). ATTENTION: When milling in the
direction of rotation (synchronous running), the
power tool can be ripped out of your hand.
POF 1200 D3