Operation; Before Every Operation; Install And Remove Battery - TOOLCRAFT PSH-L0218-E Originalbetriebsanleitung

9.6.3 Adjust angle of inclination
In order to enable an optimal working position, the chain saw head can be inclined by 15 ° and 30 °.
1. Press and hold the locking device (18) of the inclination angle.
2. Set the desired angle of inclination.
3. Release the lock. Make sure that the chain saw head clicks into place.
The angle of inclination is set.

10 Operation

10.1 Before every operation

Check the power tool for damage. Do not use if the power tool is damaged or the safety devices are defective.
Replace worn and damaged parts before using the power tool.
Check all screw and plug connections, especially the screws of the blades, as well as all locks for tight fit and all
moving parts for ease of movement.

10.2 Install and remove battery

Read the operating instructions for the battery before inserting it.
10.2.1 Install the battery
1. Slide the battery into the battery holder. You will hear a "click" when the battery lock engages.
2. Check that the battery is firmly seated.
10.2.2 Remove the battery
1. Press and hold the battery release button.
2. Pull the battery out of the battery holder.
If the battery cannot be removed easily, the battery release button was not pressed enough.
40