Mounting And Adjustment; Mount And Adjust The Additional Handle; Attach Shoulder Strap - TOOLCRAFT PSH-L0218-E Originalbetriebsanleitung

9 Mounting and adjustment

9.1 Mount and adjust the additional handle

1. Remove the fastening screws on the additional handle (4) and remove the clamping plate.
2. Place the additional handle on the pipe (7) and fix it with the clamping plate.
3. Move the additional handle to the required position and tighten the fastening screws.

9.2 Attach shoulder strap

Wear the shoulder strap (5) to work without getting tired. To be able to open the shoulder strap quickly in the event of
an accident, the shoulder strap is equipped with an accelerator (13).
1. Put the shoulder strap on so that it runs over your shoulder and crosses your chest and back.
2. Fasten the shoulder strap with the hook on the eyelet (2).
3. Adjust the length of the belt so that the accelerator (13) is at hip height.
4. To adjust the belt position on the power tool, loosen the fastening screw and move the eyelet on the pipe (7). Then
tighten the screw again.
36