Herunterladen Inhalt Inhalt Diese Seite drucken

Wireless Dmx-Mode - Litecraft WashX.432 sw Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

WIRELESS DMX-MODE

The unit is equipped with a connector for an optional LUMENRADIO CRMX Wireless DMX-module. The module is
compatible to CRMX transmitter units from LUMENRADIO and WIRELESS SOLUTIONS transmitter units version G3
and G4.
For the use with CRMX the LUMENRADIO CRMX Wireless DMX-module needs to be plugged to the backside
USB-connector and the unit must be set to one of the five DMX-modes. Press MODE button and use
UP/DOWN buttons until display shows „DMX Chan". Press ENTER and choose the right mode by use of
UP/DOWN buttons. Furthermore you need to choose the corresponding DMX-start adress. Which mode is the
right one for you is up to the range of functions you would like to use, the library and the channels of the used
DMX-controller. Please read chapter DMX-Mode of this manual to get an idea of which channels can be
controlled in which DMX-mode.
Up next there is a need for logical connection (pairing) of the unit with external DMX-transmitter. Press
CONNECT button on DMX-transmitter shortly. The transmitter searches for all available units and connects to
them. The logical connection (pairing) is done and safed until it is released manually.
NOTE!
If a unit is not connecting to an external DMX-transmitter it is already connected logical to another transmitter. In this
case the connection needs to be released manually. Press and hold CONNECT button on the LUMENRADIO CRMX
Wireless DMX-Module for at least 3 seconds. After this please repeat the procedure for logical connection (pairing) whilst
pressing CONNECT button on DMX-transmitter shortly again.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis