Installation - Litecraft WashX.432 sw Bedienungsanleitung

INSTALLATION

There are specific regulations like DGUV V17/18 (old BGV C1) or country related regulations which need to be respected
during the installation. Only skilled persons may install the device.

Suspension device has to be built and calculated in order to handle up to 10 times its specific load limit over a
time of one hour without permanent or harmful deformation.

Installation has to be done with a separate, independent suspension device like a safety chain. A second
suspension device has to be built in order to assure that in case of error no part of an installation can fall off.

Trepassing the danger zone below the installation during the assembling is prohibited.

Installer has to make sure all safety and machinery installations are approved by authorized persons before first
operation or after changes before restarting.

Installer has to make sure that all safety and machinery installations are approved by skilled persons at least
once a year.

Installer has to take care of all safety and machinery installations being approved by authorized persons at least
every four years during the acceptance inspection.

The spotlight should ideally be installed outside peoples lounge area.
ATTENTION!
Installation overhead needs a high level of experience. This includes (but is not just limited to) calculation and
definition of load capacity, used installation material and regular safety inspections of used material and the fixture
itself. Never try to do the installation by yourself if you are not qualified. Turn to a skilled installer instead.
Inappropriate installations can cause injuries and/or damage of property.

The spotlight has to be installed outside areas where people can touch it.

A professional truss system or similar licensed suspension systems have to be used if the spotlight is used in
suspension from ceiling or other constructions. Spotlights can never be installed freely suspended!
ATTENTION!
Spotlights can cause injuries when falling off. If you are not trained in questions of safety for the different kinds of
installations DO NOT install the spotlight!

Assure that the mounting surface can carry at least ten times the point load of the spotlight before installing the
fixture.
ATTENTION!
Assure the specified safety distances to flammable materials.

Attach the spotlight with its yoke and the use of a suitable hook/clamp to your truss system. According to your
installation also similar but approved suspension devices are possible. The therefore used opening has a
diameter of about 10 mm.

When installing the spotlight overhead, make sure to secure the fixture with a safety chain which is specified at
least with a load limit of 12 times of the spotlight's weight. Only safety chains with approved connections can be
used. Attach the safety chain to its designated opening and attach it to the truss system or a similar and safe
attachment point. Assure to close the fasteners as specified.

To adjust the angle of the fixture, open the locking screw, set the fixure in its position and close it by hand again.