Rational iCombi Pro Umbauanleitung Seite 11

1 | MI_2207: Automatic ignition controller iCombi – removal and installation
Therefore check the unit for service error 33.5 before replacing the automatic
ignition controller. Only replace the automatic ignition controller if service error
33.5 is displayed or if this is expressly specified by the error description of an-
other service error.
Revision Log
Changes from previous version of this manual:
Chapter "Note" added
n
Work steps – removing the iCombi automatic ignition controller
a
The unit is voltage-free and the left side panel is open.
1. Loosen the blind rivets with threaded pin on the automatic ignition control-
ler.
2. Pull the automatic ignition controller out of the unit.
11 / 88