Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If the charger's Ethernet port is needed to be set in DHCP mode, this should be done from the webconfig interface.
2.12 - WEBCONFIG UI ENABLE / DISABLE
If you need to enable/disable the WebConfig UI below steps should be followed:
•
Make sure the charging station is powered-off and open the front cover of your charger which is mentioned
in installation guideline.
•
If you want to enable the WebConfig UI, third position of dipswitch should be in "OFF" position as shown
in figure 28.
•
If you want to disable the WebConfig UI, third position of dipswitch should be in "ON" position as shown
in figure 28.
IG v7.3.0 2021
Toggle
Toggle
Figure.27
Figure.28
© 2021 Vestel - All rights reserved
ON
1
2
3
4
5
ON
ON
1
2
3
4
5
OFF
6
6
English - 33
Werbung
Inhaltsverzeichnis
