Change calibration and memorise
Change the volume displayed to the volume which has been filled
Operation
or
Memorise volume detected
At the same time press for approx. 5 seconds
3.6.2 Change calibration factor (from serial no. 0213-00100 2000)
Requirement: The partial quantity has been reset to 0.00.
Switching into calibration mode
Operation
At the same time press for approx. 5 seconds
Change calibration
or
Memorise volume detected
At the same time press for approx. 5 seconds
3.6.3 Stop calibration without change
Requirement: The flow meter is in the calibration mode.
GB
Display
Display
9