Cleaning And Maintenance; Storage; Electrical Connection - Scheppach 5901504901 Original Bedienungsanleitung

11. Cleaning and maintenance

Warning! Prior to any adjustment, maintenance or
service work disconnect the mains power plug!
General maintenance measures
Wipe chips and dust off the machine from time to time
using a cloth. In order to extend the service life of the
tool, oil the rotary parts once monthly. Do not oil the
motor.
When cleaning the plastic do not use corrosive prod-
ucts.
Cleaning
Keep all safety devices, air vents and the motor hous-
ing free of dirt and dust as far as possible. Wipe the
equipment with a clean cloth or blow it with com-
pressed air at low pressure.
We recommend that you clean the device immediately
each time you have finished using it.
Clean the equipment regularly with a moist cloth and
some soft soap. Do not use cleaning agents or sol-
vents; these could attack the plastic parts of the equip-
ment. Ensure that no water can seep into the device.
The ingress of water into an electric tool i creases the
risk of an electric shock.
Maintenance
• Always replace damaged tailstocks (new for old).
• There is a limit switch inside the device that switch-
es off the machine as soon as the housing cover is
opened. This also prevents the machine from being
switched back on while the housing cover remains
open. Always ensure that this unit functions correct-
ly.
• Since the machine is equipped with a mechanical
brake, check the run-on and braking times of the
machine at regular intervals. This must not exceed
10 seconds. If the measured shut-down time ex-
ceeds 10 seconds, do not continue operating the
machine. Contact after-sales service.
• In the course of time, the rubber wrapping on the
blade wheels develops cracks and gets worn. This
prevents the saw blade from operating precisely.
Workplace safety and machine operation are ad-
versely affected by this.
Replace the blade wheels!
38 | GB
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: Carbon brushes, saw blade, table inlays;
v-belt
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.

12. Storage

Store the device and its accessories in a dark, dry and
frost-proof place that is inaccessible to children. The
optimum storage temperature is between 5 and 30˚C.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical tool.

13. Electrical Connection

The installed electric motor is connected and is ready
to work.
The connection complies with the relevant VDE and
DIN regulations.
The customer-side mains supply and the used exten-
sion line must meet these regulations.
Important information
In the event of an overloading the motor will switch
itself off. After a cool-down period (time varies) the
motor can be switched back on again.
Defective Electric Connection Lines
Often, insulation damages occur on electrical connec-
tion lines.
Causes are:
• Drag marks if connection lines are led through win-
dow or door clearances.
• Kinks due to improper attachment or routing of the
connection line.
• Cuts caused by running over the connection line.
• Insulation damages caused by pulling the connec-
tion line out of the wall socket.
• Fissures caused by the ageing of the insulation.
www.scheppach.com