Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fitting and installation
Transport
NOTICE
Risk of damage!
■ If a trolley is used to move the oven,
the appliance must be lifted as shown
on the packaging.
Your oven comes in sturdy packaging and is
so heavy that it should not be carried by one
person alone.
General installation
The oven has been designed to be built into
a kitchen unit. If you have the requisite skills,
you can fit it yourself.
However, the electrical connection must be
carried out by an authorised professional
Fitting and installation
Required materials
(6)
(7)
(6) 4× Bracket for attaching the glass
ceramic hob to a worktop
(7) 4× Screw for attaching bracket
(8) 2× Screw for attaching oven
Installation requirements
• The hob may only be installed with one
side next to higher kitchen furniture, ap-
pliances or walls.
– The worktop must be positioned horizon-
tally, and it should be sealed against any
overflowing liquids on the wall side.
– The oven should not be installed directly
beside refrigerators or freezers. Heat out-
put increases their energy consumption
unnecessarily.
– Keep the oven at least one centimetre away
from the wall. The cooker power connec-
tion must therefore be a flush-mounted
box or must be located outside the instal-
lation space.
– The hob and oven are connected by the
permanently installed wiring harness; they
must therefore be installed in direct align-
ment to each other.
– Veneers, plastic coverings and adhesives
which are used must be resistant to heat
(100 °C).
– The minimum distances defined below
must be observed.
Page EN-29
(8)
Werbung
Inhaltsverzeichnis
