SPORTSTECH sBike Benutzerhandbuch Seite 32

6.8 MONITOR HOLDER TUBE
127
• Slide the cover cap ('1') with the open side facing up onto the front tube ('14').
• On the upper part of the front tube ('14'), loosen the rubber band on the connector ('127').
• Pass the connector of cable '127' through the monitor holder tube ('8'). However, do not pass it through
the mounting plate.
• Insert the monitor holder tube into the front tube so that the mounting plate points symmetrically to
the rear.
• Turn 2 screws '121' through the holes in the front tube ('14') into the threaded holes in the monitor
holding tube ('8').
• Tighten the screws by hand using an Allen key.
32
8
1
121
14
#121 2X
M6 x 8l
#135 6X
#123 1X