Replacing Blades; Storage; Disposal/Environmental Protection - Parkside PRMA 40-Li B3 Originalbetriebsanleitung

Replacing blades

If the blade is blunt, it can be re-sharpened
by a specialist company. If the blade is
damaged or unbalanced, it must be re-
placed.
1. Turn the machine over.
2. Use firm gloves and keep hold of the
blade (23). Use a spanner (SW14) to
turn the blade bolt (24) counter-clock-
wise from the motor spindle (25).
3. Reassemble the new blade (23) in re-
verse order. Make sure that the blade
(23) is positioned correctly (see illustra-
tion ) and that the blade bolt (24) is
tightened.

Storage

Release the tightening levers (2+5) and
fold the upper bar (1) and the lower bar
(3) together so that the device takes up less
space. Make sure not to pinch the machine
cables while doing this.
• Store the device in a dry place out of
reach of children.
• Give the motor time to cool off before
you store the device in an enclosed
space.
• Remove the rechargeable battery
before storing the device for a long pe-
riod of time (e.g. winter storage).
• The storage temperature for the recharge-
able battery and the device is between
0°C and 45°C. Avoid extreme cold or
heat during storage to ensure the battery
output is not adversely affected.
We are not liable for damage cause by
our devices if this is caused by improper
repair, the use of non-original parts or in-
correct use.
Disposal/environmental
protection
Remove the rechargeable battery before
disposing of the device.
The device, accessories and packaging
should be properly recycled.
Detailed instructions on how to dispose of
the rechargeable battery can be found in
the separate instruction manual for your
battery and charger.
Electrical devices do not belong in
domestic waste.
• Do not throw cut grass into the rubbish
bin; instead, take it for composting or
spread it as a mulch below shrubs and
trees.
In accordance with the Directive
2012/19/EU on waste electrical and elec-
tronic equipment, used electrical devices
must be collected separately for disposal
and recycled in an environmentally sound
manner.
Depending on the implementation in na-
tional law, you may have the following
options:
Return to a shop,
Return to an official collection point. For
more information, please contact your
local waste management provider or our
service centre.
Return to the manufacturer/distributor. We
will dispose of any defective devices that
you send to us free of charge.
This does not affect accessories enclosed
with the old devices or tools without any
electrical components.
GB MT
35