Replacing Blades; Adjusting The Carburettor; Storage; General Storage Instructions - Parkside PBM 125 A1 Originalbetriebsanleitung

GB IE

Replacing blades

Improper installation can
cause severe injury.
Never tilt the lawnmower to
the side or forwards when
the petrol or oil tank is filled!
This could damage the engi-
ne, voiding the warranty.
Check the blade for wear and damage. If
dull or damaged, replace the blade!
Always have a specialist workshop
sharpen a dull blade, as they can
perform imbalance testing.
Wear gloves when handling the
blade.
Once you have loosened the blade
screw (35), you have to replace the
clamping disk (37).
The tightening torque of the blade
is 45 Nm.
1. Disconnect the spark plug connector (12).
2. Put the device in the maintenance posi-
tion (see Figure
3. Use firm gloves and keep hold of the
blade (34). Use a spanner to turn the
blade bolt (35) counter-clockwise from
the motor spindle (36).
3. Reassemble the new blade in the rever-
se order.
Make sure that the blade is positioned
correctly and resting flush on the engi-
ne spindle.
The clamping disk (37) must be posi-
tioned between the blade screw and
blade.
4. Tighten the blade with 45 Nm.
40
).

Adjusting the carburettor

The carburettor has been preconfigured
for ideal performance at the factory. If any
readjustments are necessary (see "Trou-
bleshooting"), have the adjustments made
by a specialist workshop.

Storage

General storage instructions

Never store the device with
the grass collection box full.
If the weather is too hot, the
grass will begin to ferment
under heat. Possible fire ha-
zard.
• Clean and maintain the device prior to
storage.
• Give the engine time to cool off before
you store the device in an enclosed
space.
• Use suitable, permissible containers for
storing the fuel.
• Store the device in a dry and dustproof
location and out of reach of children.
• Do not enclose the device in nylon
sacks as this may cause moisture or
mould to form.

Folding up the device

For space-saving storage the grip rod can
be folded twice.
1. Remove the grass collection
box (
21).
2. Unhinge the starter cable (
3. Open the quick release levers (7) on
the lower bar (4).
4. Turn the quick release levers (7) cross-
wise towards the bar. Gently pull the
24).