Christopeit Sport RMT 8200 Montage- Und Bedienungsanleitung Seite 15

STEP 4:
Attach the rear foot (24) and foot pedals (34).
1. Put the rear foot (24) into the holder at seat rail (6) and screw it
tightly by using screw M10x110 (22), screw M8x45 (23), washers (5)
and self locking nut (10).
2. Screw into below threats at main frame the screws M12x170 (33).
Then attach the foot pedals (34) at main frame (1) into appropriate
position in upper threats with screws M12x170 (33). (For safe exercise
condition of the rowing machine, the star grip screw No. 32 must be
firmly tightened, before user take exercise position. The height-adjus-
table foot 20 under the seat rail must be adjusted in such a way, that it
does not touches the ground, when it's folded out. During fold up, the
height-adjustable foot touches the ground and serves as a standfoot.)
STEP 5:
Attach the computer (38) at computer support (48).
1. Push the connecting cable (49) and sensor connection cable (37)
through the computer holder (44) into front position.
2. Put the computer holder (44) with two plastic washers (42+43)
onto the computer support (48) and attach it with carriage bolt M8x75
(39), washer (5) and nut (31).
3. Remove the 4 screws (51) from backside of computer (38). Lead
the computer (38) to computer holder (44) and push the plug of the
connecting cable (49) and sensor connection cable (37) into the asso-
ciated socket of the computer (38).
4. Storage the cable connection into the backside of computer (38)
and put the computer (38) on the computer holder (44) and attach it
with the screws (51).
Note: If the set position of computer change automatically during exer-
cising, then tighten the nut (31) a little bit at the computer support (44)
for a fixed incline position, as well as the nut (31) behind the plug (53)
for computer height position.
STEP 6:
Attach the power.
1. Please insert the plug of adaptor (47) to the power plug (82) at end
of chain guard.
2. Please insert the plug of adaptor (47) to the jack of wall power
(230V~50Hz).
15
GB