Assembly Instructions - Christopeit Sport Rmt 8200 Montage- Und Bedienungsanleitung

ASSEMBLY INSTRUCTIONS

Remove all the separate parts from the packaging, lay them on the
floor and check roughly that all are there on the base of the assembly
steps. Please note that a number of parts are connected directly to the
main frame preassembled. In addition, there are several other indivi-
dual parts that have been attached to separate units. This will makes
assembly easier and quicker for you. Assembly time: 30 min.
When removing the components from the carton, make sure that the
handlebar (50) turn only 90° to the right and position into the handle
holder.
Part „A" serves as a transport sa-
fety device and it is no need after
build up.
STEP 1:
Attach the front stabilizer (2) to main frame (1).
1. Attach the front stabilizer (2) assembled with end caps with trans-
portation rollers (3) to main frame (1), using inner hex screw M8x75 (4)
and washers (5).
2. Screw in the adjustable foot (20) into appropriate position at main
frame (1) and secure the position by nut (19) to level the item into a
stabile stand.
STEP 2:
Attach the seat rail (6) at main frame (1).
1. Place the connection U-plate (11) onto the seat rail (6), so that the
holes pattern and screw the connection U-plate (11) at seat rail (6) by
using screws M8x20 (12) and washers (5).
2. Lead the seat rail (6) against the main frame (1) and connect the
sensor 1 (46) with sensor connection cable (37).
3. Place the connection U-plate (11) onto the holder of main frame
(1), sothat the side holes pattern and tighten the connection U-plate
(11) at main frame (1) by using screw M10x125 (8), washer (9) and nut
(10). Don't tighten the screw (8) too much, sothat the fold up system
works easy.
4. Secure the seat rail (6) before training by screw in the hand grip-
screw (32) with washer (13) and lock up with quick release (14).
STEP 3:
Attach the seat slide (27) with seat (25) at seat rail (6).
1. Screw out the limit stopper (15) from seat rail (6) and push the seat
slide (27) with preassembled seat (25) onto the seat rail (6) in the right
way as showed in figure Step 3.
2. Fix the limit stoppers (15) at appropriate position of seat rail (6) by
using axle for limited stopper (16), washer (17) and screw (18).
14
GB