Ego Power+ ZT4200E-S Originalanleitung Seite 41

NOTE: If a fault code appears on LCD screen, remove all battery packs and re-insert them a few minutes later. If this
doesn't solve the problem, follow the fault code troubleshooting below.
LCD
Description
Display
Seat sensor icon shows on
the LCD
PTO Switch icon blinks
Energy regeneration icon
blinks occasionally.
CCS icon blinks
Fault
Mower
Code
Status Beeper
on
Indicator
LCD
n/a OFF No
n/a OFF No
n/a OFF No
n/a OFF No
Cause Solution
If with the operator
is seated on the seat
and the icon is on,
stop operating the
The operator
mower immediately
leaves the seat
and check the seat
or the seat safety
connection. If the seat
interlock system
connection with the
is disconnected.
mower is confirmed
correct, please contact
a qualified service
technician for repairs.
Before restarting
the mower, push the
The blade motor
PTO switch down
was interrupted in
to turn off the blade
operation and the
motors. Please see
PTO switch is not
"TROUBLESHOOTING"
set to off position.
section in this manual
for reference.
The kinetic
energy generated
during braking or
This is normal
driving downhill
operation. No action is
is converted into
needed.
electricity to
charge the battery
packs.
The CCS function could
The CCS (cruise
not be set when the
control system)
mower is driving at very
function has
low speed or is driving
failed.
in reverse.
ZERO TURN RIDE-ON MOWER — ZT4200E-S
EN
41