Ego Power+ ZT4200E-S Originalanleitung Seite 29

TROUBLESHOOTING
PROBLEM CAUSE
◾
◾
◾
◾
The zero turn ride-on
mower fails to drive
when the accelerator
◾
pedal is depressed.
◾
◾
◾
The combined Ah of the
inserted batteries does not
meet the requirement.
The parking brake pedal is
set in the braking position.
The both left and right
paddles are not briefly pulled
toward the operator to make
the mower status indicator
shine green when starting
the mower.
The operator is not sitting on
the seat.
The seat switch is not
connected correctly.
Under extreme cold weather,
the driving function may not
start successfully due to the
low temperature protection.
The travel path of the
accelerator pedal is clogged
with debris.
Failure of mechanical or
electronic components of the
accelerator pedal.
SOLUTION
◾
In order to start this mower, use enough EGO
batteries following the instructions in section
"ATTACHING/DETACHING THE BATTERY PACK" in
this manual.
◾
Fully depress the parking brake pedal to release it
from the braking position.
◾
Pull BOTH left and right paddles toward the operator
simultaneously and then release. The mower status
indicator will shine green, which means the mower
is ready to start.
◾
Only when the operator correctly sits on the seat,
can he operate the mower.
◾
Remove the battery from the mower and
disassemble the seat in the reverse order of the
instructions in section "INSTALLING THE SEAT"
in this manual to make sure that the cable plug is
properly connected to the socket on the bottom
of the seat. Reassemble the seat and follow the
instructions in "STARTING THE MOWER" to restart
the mower to see if the mower can be started. If not,
contact a qualified service technician for repair.
◾
Always store the mower and battery in warm
environment. Restart the mower when it is warmed
up. Please do not make repeated attempts under
extreme cold weather which may damage the
machine.
◾
Check and remove the debris.
◾
Contact a qualified service technician for repair.
ZERO TURN RIDE-ON MOWER — ZT4200E-S
EN
29