Ego Power+ ZT4200E-S Originalanleitung Seite 27

◾
Remove the batteries from the
mower.
◾
Remove the safety key from the
mower.
◾
Perform all maintenance
procedures listed above and
Before storage
thoroughly clean the mower.
◾
Inspect the entire product for
damaged, missing, or loose
parts, replace or tighten the
corresponding ones before
storage.
◾
Check the parking-brake pedal.
Remove the battery from the
mower and set the parking-
brake pedal at the braking
position. Manually push the
Annually
mower forwards to see whether
the mower can be moved or not.
If it moves, have it serviced by a
qualified service technician.
GENERAL MAINTENANCE
Cleaning the mower housing (Fig. F1 – F2)
Using wash port to clean mower deck (Fig. F3 – F4)
F3-1 Wash Port
F3-3 Garden Hose
NOTICE: When finishing cleaning, turn off the mower
completely and then remove the garden hose and quick-
coupler.
MAINTAINING THE MOWER DECK AND THE
CUTTING BLADES
Preparation (Fig. G1)
Removing the mower deck (Fig. G2 – G3)
G2-1 Motor Cable
G2-3 Cotter Pin
NOTICE: Disconnect all motor cables and cotter pins
when removing the mower deck.
F3-2 Wash-Port Quick
Coupler
G2-2 Suspension Linkage
Replacing the cutting blades (Fig. G4 – G6)
G4-1 Stabilizer
G5-2 Washer
G5-4 Flange
Leveling the mower deck
a. When to level (Fig. G7 – G9)
b. Before leveling
◾
Checking the cold tire pressure (Fig. G10)
◾
Check the cutting blades. Remove and replace
worn, cracked, and/or bent blades as necessary.
c. Preparation for leveling (Fig. G11)
d. How to leveling
◾
To make side-to-side adjustment (Fig. G12)
◾
To make front-to-rear adjustment (Fig. G13)
CALIBRATING THE MOWER TRACKING
SYSTEM (Fig. H1 – H2)
NOTICE: The beeping indicator will sound once both
when starting calibration and when the calibration is
finished.
NOTE: The calibration completed for one of the driving
modes ("CONTROL", "STANDARD", "SPORT") maybe not
available for the other two modes. Calibrate the steering
wheel in each driving mode independently as needed.
RESETTING THE MOWER TO INITIAL FACTORY
SETTING (Fig. I)
NOTICE: The beeping indicator will sound once both when
starting resetting and when the resetting is finished.
NOTE: When the resetting is successful, below settings
will return to the initial factory setting:
◾
driving mode
◾
driving speed
◾
calibration of the steering wheel
STORAGE & TRANSPORT
TRANSPORTING THE MOWER (Fig. J1 – J5)
NOTICE: Secure the mower as needed, using straps or
cables to prevent movement during transport.
ZERO TURN RIDE-ON MOWER — ZT4200E-S
G5-1 Bolt
G5-3 Blade
G5-5 Motor Shaft
27
EN