Ego Power+ ZT4200E-S Originalanleitung Seite 35

PROBLEM CAUSE
◾
The charging time via Using EGO Adapter ACA1000
the mower charging for charging requires long
port is too long. time.
◾
The battery cannot be Firmware bug of the mower
fully charged via the or the battery or the charger
mower charging port. failure.
◾
Improper cleaning, such as
The mower cannot be
water getting on the electric
started after cleaning.
components, LCD screen etc.
◾
The mower deck was not
The mower deck gets
properly cleaned after
clogged fast.
previous use.
◾
The tires of the rear wheels
The mower easily
are worn.
loses traction when
climbing up on the
◾
Mowing on a steep slope.
slope.
When the mower is
◾
stopped on a slope The brake components are
with the parking-brake excessively worn due to
pedal pressed, the improper operation of the
mower can roll down mower.
the slope.
There is no water
◾
The wash-port quick coupler
coming from the wash
is not properly mounted onto
port when attempting
the wash port.
to wash the deck.
An abnormal sound is
◾
The sound comes from the
heard when manually
magnets inside the driving
pushing the mower
motor.
without starting it.
◾
The steering wheel The steering wheel assembly
cannot be rotated. is clogged with debris.
The mower does not
◾
turn left/right when Failure of electronic or
the steering wheel is mechanical components.
rotated.
◾
The return path of the
accelerator pedal is clogged
with debris.
The mower fails to
◾
stop when releasing
The CCS button is pressed
the accelerator pedal.
unintentionally while driving.
The mower is in cruise-
control mode
SOLUTION
◾
Use EGO charger CHV1600E for charging the zero
turn ride-on mower directly.
◾
Reset the charger by unplugging the charger and
waiting for longer than several minutes. Then
reconnect the plug to the power supply. If this does
not solve the problem, call EGO Customer Service
Center.
◾
Follow the instructions in section "GENERAL
MAINTENANCE"to clean the mower correctly.
◾
If the mower caught in rain accidentally, leave it in
the air to dry or use compressed air to dry it.
◾
Clean the mower deck after each use, following the
section "USING WASH PORT TO CLEAN MOWER
DECK".
◾
Seek local service to replace the wheel tires.
◾
The mower should not be used to mow slopes
steeper than at required degree.
◾
Call EGO Customer Service Center for repair.
◾
Re-attach the wash-port quick coupler until you hear
a clear click after firmly pushing. If it does not work,
call EGO Customer Service Center.
◾
It is normal and no action is needed.
◾
Check and remove the debris.
◾
Call EGO Customer Service Center for repair.
◾
Check and remove the debris.
◾
Check if the CCS icon is illuminated on the LCD
screen, and exit the CCS as necessary. Refer to
chapter "USING CRUISE CONTROL (CCS)"
ZERO TURN RIDE-ON MOWER — ZT4200E-S
EN
35