Inserting The Oven; Basic Cleaning - hanseatic HBO7213A1 Gebrauchsanleitung

Inserting the oven

NOTICE
Risk of damage!
Improper handling of the appliance
can result in damage.
■ Do not set the oven down on the edge
or corner of the oven door! The glass
panes can be damaged.
1. Push the oven into the recess until the
front fascia is flush with the installation unit.
The mains connection must not be kinked,
pinched or otherwise damaged.
2. Ensure an even gap between the oven
and the unit walls on both sides.
3. Do not seal the gap above the oven fascia.
4. If the oven is correctly set up, open the
oven door and screw it to the built-in cup-
board using the included assembly materi-
al. Use the screws and screw inserts.
5. Switch the socket fuse back on.
Installing, connecting and start-up

Basic cleaning

The oven must be pre-cleaned to remove all
grease and oil residues from the manufactur-
ing process, as well as tough dust deposits
left over from storage and transportation. This
not only helps protect your health but also en-
sures delicious cakes and roasts.
1. Operate the oven with dripping pan, oven
rack and baking tray for 60 minutes at
250°C.
Refer to the chapter "Operating the oven"
for the oven's operating instructions.
2. Allow the oven to fully cool down.
3. Clean the cooking compartment of the
oven, as well as the dripping pan, oven
rack and baking tray with a little soapy wa-
ter and then wipe everything dry.
Page EN-27