Appliance With Adjustable Connected Load; Installation; Standard Installation - STIEBEL ELTRON DHB-E 11 SLi electronic Bedienung Und Installation

INSTALLATION

Installation
9.3

Appliance with adjustable connected load

The appliance DHB-E 18/21/24 SL is set to 21 kW when delivered.
If the appliance is to be installed with a different output, take the
following steps:
f Plug in the coding card according to the selected output; for f
selectable output and fuse protection of the appliance, see
chapter "Installation / Specification / Data table".
f Tick the selected output on the type plate. Use a permanent f
marker for this.
f Install the flow limiter with an output corresponding to that f
of the appliance (see chapter "Installation / Specification /
Data table").
10. Installation

Standard installation

- Electrical connection from below on unfinished walls
- Water connection on unfinished walls
For further installation options, see chapter "Installation /
Installation options":
- Electrical connection from above on unfinished walls
- Electrical connection on finished walls
- Large conductor cross-section for electrical connection from
below
- Connecting a load shedding relay
- Water installation on finished walls
- Water installation on finished walls with solder / compres-
sion fitting
- Water installation on finished walls; fitting the appliance
cover
- Fitting the base part of the back panel with threaded fittings
on finished walls
- Wall mounting bracket when replacing an appliance
- Installation with offset tiles
- Pivoting appliance cover
- Temperature limit / Anti-scalding protection
www.stiebel-eltron.com
10.1 Standard installation
Opening the appliance
f Open the appliance by pulling the flap forwards and down- f
wards, undo the screw and lift up the appliance cover.
f Remove the back panel by pressing the two locking hooks f
and pulling the base part of the back panel forwards.
Preparing the power cable
160
30
1 Installation aid
f Prepare the power cable. f
Fitting the wall mounting bracket
f Mark out the holes for drilling using the installation template. f
If the appliance is to be installed with water connections on
finished walls, also mark out a fixing hole in the lower part
of the template.
1
DHB-E SLi | 27