STIEBEL ELTRON DHB-E 11 SLi electronic Bedienung Und Installation Seite 28

INSTALLATION
Installation
f Drill the holes and secure the wall mounting bracket at 2 f
points using suitable fixing materials (screws and rawl plugs
are not part of the standard delivery).
f Fit the wall mounting bracket. f
Making the water connection
Material losses
!
Carry out all water connection and installation work in
accordance with regulations.
f Seal and insert the twin connectors. f
2
2
1
3
5
4
1 DHW with tee
2 Gasket
3 Cold water with 3-way ball shut-off valve
4 Strainer
5 Flow limiter or plastic profile washer (see chapter "Installa-
tion / Water installation / Flow rate")
Note
A second flow limiter is provided with the DHB-E 18/21/24
SL. Install the appropriate flow limiter for output of the
appliance (see "Flow rate regulator" in chapter "Installa-
tion / Specification / Data table"):
4.0 l/min = pink
7.5 l/min = blue
8.5 l/min = green
f Secure the tee and and 3-way ball shut-off valve, each with a f
flat gasket, to the twin connector.
Material losses
!
Never use the 3-way ball shut-off valve in the cold water
inlet to reduce the flow rate.
28 | DHB-E SLi
Installing the appliance
f For easier installation, push the cable grommet of the upper f
electrical connection into the back panel from behind.
f Remove the transport plugs from the water connections. f
f Remove the fixing toggle from the upper part of the back f
panel.
f Route the power cable through the cable grommet from f
behind until the power cable rests against the cable sheath.
Align the power cable.
Enlarge the hole in the cable grommet if the cross-section of
the power cable is > 6 mm².
f Push the appliance over the threaded stud of the wall mount- f
ing bracket, so that it breaks through the soft seal. If neces-
sary, use a screwdriver.
f Push the fixing toggle on to the threaded stud of the wall f
mounting bracket.
f Push the back panel firmly against the wall. Lock the fixing f
toggle by turning it 90° clockwise.
f Fit the pipes with flat gaskets onto the twin connectors. f
Material losses
!
The strainer must be fitted for the appliance to function.
f When replacing an appliance, check whether the f
strainer is installed.
www.stiebel-eltron.com