Herunterladen Inhalt Inhalt Diese Seite drucken

Interrupting The Wash Process; Drainage And Switching Off The Machine - Fagor evoCONCEPT CCO-120DCW Installations-, Gebrauchs- Und Wartungsanleitung

Transportspülmaschine
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 83
EN
5.9.4

Interrupting the wash process

The wash and rinse processes are deactivated after the baskets have passed through the machine and the
feed belt automatically stops after 10 minutes without detecting incoming baskets.
If, at any time, it is necessary to interrupt the wash process, the best way is to Press the START/STOP
(Fig. 12): The feed belt stops and the wash and rinse processes are interrupted. If the button is pressed
again within a short period of time the machine will start to operate again. If not, only the feed belt starts
again.
Other ways to stop the machine, but which are not recommended unless absolutely necessary, include
the following:
Selecting position 0 using the SELECT (Fig. 12): This will switch off the machine. The wash
process is not restarted. Any basket that is in the appliance when the machine is stopped should
be reinserted as the wash has been interrupted and not completed correctly.
Opening the door (CAUTION!): The feed belt stops and the wash and rinse processes are
interrupted, but hot water may splash and cause burns.
Using the emergency button ES (Fig. 3, Fig. 4): the machine is switched off and stops operating
completely. ONLY USE IN THE EVENT OF EMERGENCY.

5.10 Drainage and switching off the machine

At the end of the working day or when it is necessary to change the wash water because it is too dirty, the
wash tank should be drained.
To drain the machine, just remove the overflow. The machine should be switched off first.
To switch off the machine, select position 0 using the SELECT (Fig. 12).
At the end of the working day, the appliance should be drained and the water disconnected, using the shut-off
valve, and the electricity disconnected, using the magneto-thermal switch/ setting the mains switch IG (Fig.
3/Fig. 4) to OFF, and the machine cleaned (See instructions for cleaning in the manual).
Leave the door open to help dry the inside of the machine and to prevent bad odours when the machine is not
in use.
78
At the end of the day, the machine must be
cleaned. Follow the instructions given in this
manual with respect to cleaning.
IMPORTANT:
WAIT AT LEAST 10 MINUTES AFTER SWITCHING OFF AND DRAINING
THE MACHINE BEFORE CLEANING THE INTERIOR.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis