Ferm HTM1005 Originalbetriebsanleitung Seite 8

Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardized test given in
EN 62841; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level.
• The times when the tool is switched off or
when it is running but not actually doing the
job, may significantly reduce the exposure
level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping your
hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. On/Off button
2. Battery (not included)
3. Battery unlock button
4. Cutting blade
5. Protection guard
6. Front handle
7. Safety switch
8. Transport protection
3. ASSEMBLY
Before any work on the power tool,
remove the battery.
The battery must be charged before first
use.
Mounting the front handle (Fig. B)
1. Put the front handle (6) on the machine, as
shown on figure B.
2. Mount the front handle (6) by tightening the
screw.
Mounting the protection guard (Fig. C)
You may not use the hedge trimmer
without the protection guard
8
1. Put the protection guard (5) on the machine, as
shown on figure C.
2. Mount the protection guard (5) by tightening
the screw.
Inserting the battery into the machine (Fig. A, D)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (2) into the base of the
machine as shown in Fig. D.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig.
A, D)
1. Push the battery unlock button (3)
2. Pull the battery out of the machine like shown
in Fig. D.
4. OPERATION
Before using, always visually inspect to
see that the blades, blade bolts and
cutter assembly are not worn or
damaged.
You may not use the hedge trimmer
without the protection guard.
Always use both hands to hold the
hedge trimmer and keep it away from
your own body.
Using your hedge trimmer
• For your own safety and for best results read
the following user advice and do not use this
product for anything other than its intended
purpose.
• This hedge trimmer is made for cutting
hedges and bushes. All other use that is not
specifically allowed in this manual mat lead to
manage to the hedge trimmer or injury to the
user.
Switching on and off (Fig. A)
• To switch the trimmer on, press the safety switch
(7) and the start switch (1) at the same time.
• To switch off, release one or both switches.