Husqvarna TC 242TX Bedienungsanweisung Seite 37

Problem
The engine becomes too hot.
There is loss of power.
There is vibration in the product.
1923 - 005 - 13.10.2022
Cause
There is overload in the engine.
The air intake or the cooling fins on
the engine are blocked.
The cooling fan is defective.
The engine oil level is too low.
The ignition lock is defective.
The spark plug is defective.
The product is operated at too high
forward or rearward speed when you
cut grass.
The throttle control is in the choke
position.
There is build-up of grass, leaves or
unwanted material under the cutting
deck.
The air filter is dirty.
The engine oil level is too low.
The engine oil is dirty.
The spark plug is defective.
The fuel filter is dirty.
The fuel in the fuel tank is bad.
There is water in the fuel.
The spark plug wire is loose.
The air intake or the cooling fins on
the engine are blocked.
The muffler is clogged or damaged.
There is loose or damaged wiring.
The engine valves are not adjusted
correctly.
The blades are loose.
One or more of the blades are dam-
aged or not balanced.
The engine is loose.
Action
Decrease the workload.
Clean the air intake and the cooling
fins on the engine.
Speak to an approved service agent.
Do a check of the engine oil level. Fill
with engine oil if it is necessary.
Speak to an approved service agent.
Replace the spark plug.
Use slower speed.
Put the throttle control in the fast po-
sition.
Clean the cutting deck.
Clean or replace the air filter.
Do a check of the engine oil level. Fill
with engine oil if it is necessary.
Replace the engine oil.
Replace the spark plug.
Replace the fuel filter.
Replace the fuel in the fuel tank.
Remove all fuel from the fuel tank
and the carburetor. Fill the fuel tank
with new fuel and replace the fuel fil-
ter.
Connect and tighten the spark plug
wire.
Clean the air intake and the cooling
fins on the engine.
Clean or replace the muffler.
Do a check of all wiring.
Speak to an approved service agent.
Tighten bolts on the blades.
Balance the blades or replace the
blades.
Tighten the engine bolts.
37