Herunterladen Inhalt Inhalt Diese Seite drucken

Husqvarna TC 242TX Bedienungsanweisung Seite 21

Vorschau ausblenden Andere Handbücher für TC 242TX:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 229
1. Turn the ignition key counterclockwise to the ROS
"ON" position (A) to engage the ROS.
A
2. Slowly push down the reverse drive pedal to start
movement.
3. Turn the ignition key clockwise to the engine "ON"
position (B) to disengage the ROS.
To get a good cutting result
For best performance, do maintenance on the
product regularly as given in the maintenance
Maintenance schedule on page
schedule. Refer to
23 .
Do not cut a wet lawn. Wet grass can give a bad
cutting result.
Do not use tire chains when you attach the cutting
deck to the product.
Make sure that the cutting deck is level. Refer to
adjust the parallelism of the cutting deck on page
30 .
If the grass is high, start with a high cutting height
and decrease it gradually.
Move the product forward at low speed if the grass is
high and thick.
Use full throttle when you cut the grass.
Cut the grass in an irregular pattern.
Use the left side of the cutting deck when you
cut near trees, bushes or paths. The blade cuts
approximately 15 mm in from the side of the cutting
deck.
When you cut large areas, move the product to the
right during 1 or 2 turns around the work area. This
procedure will keep the grass discharge away from
shrubs, fences and driveways. After approximately
2 turns around the work area, cut in the opposite
direction.
To get the best cutting result, cut the grass
frequently.
1923 - 005 - 13.10.2022
B
To
To empty the grass catcher
The product has an alarm that goes off if the grass
catcher is full. To stop the alarm, disengage the cutting
To engage and disengage the cutting
deck. Refer to
deck on page 20 .
1. Move the product to a location where you can empty
the grass catcher.
2. Make sure that the transaxle is in the neutral position
and engage the parking brake.
3. Pull up the handle on the grass catcher to the
highest position.
4. Pull the handle forward to tilt the grass catcher and
empty the grass.
5. Push the handle rearward to lower the grass catcher.
Make sure that the grass catcher is fully lowered and
in the correct position.
21

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis