Husqvarna TC 242TX Bedienungsanweisung Seite 30

To remove and install the center chute
1. Remove the grass catcher.
2. Remove the clips (A).
A
3. Move the center chute (B) out from behind the
product.
4. Install in the opposite sequence.
To adjust the parallelism of the cutting deck
To do a visual side to side adjustment of the cutting
deck
If the cutting height is not the same on the right and left
side of the product, the cutting height can be adjusted.
Adjust the cutting height on the side of cutting deck that
has the lower cutting height.
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Go to the side of cutting deck that has the lower
cutting height.
Note:
Some models only have left side
adjustment.
30
4. Adjust the cutting height with a 3/4" wrench.
B
Note:
A
the cutting deck height 3/16" (4.7 mm).
a) Turn the lift adjustment nut (A) to the left to lower
the cutting deck.
b) Turn the lift adjustment nut (A) to the right to lift
the cutting deck.
5. Cut some grass and examine the results. Adjust if it
is necessary.
To do a precision side to side adjustment of the cutting
deck
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Put the cutting deck in the transport position. Refer
B
To set the cutting deck in transport position or
to
mow position on page 18 .
4. Turn the outer blade tips to align with the cutting
deck side to side.
5. Measure the distance (B) from the bottom edge of
the blade to the ground on the left and right side.
B
Note:
sides.
6. Adjust the cutting height with a 3/4 in wrench.
Note:
changes the cutting height with 3/16 in (4.7 mm).
A
Each full turn of lift adjustment nut changes
WARNING:
The blades on the
cutting deck are sharp and can cause
injury. Use protective gloves.
The distance must be the same on the 2
Each full turn of the lift adjustment nut
1923 - 005 - 13.10.2022
B