Husqvarna TC 242TX Bedienungsanweisung Seite 29

To connect the jumper cables
WARNING:
of explosive gas that comes from the
battery. Do not connect the negative
terminal of the charged battery to or near the
negative terminal of the weak battery.
CAUTION:
your product to start other vehicles.
1. Connect one end of the red battery cable to the
POSITIVE (+) battery terminal (A) on the weak
battery.
B
A
2. Connect the other end of the red battery cable to the
POSITIVE (+) battery terminal (B) on the charged
battery.
WARNING:
the red battery cable touch the chassis.
This will cause a short circuit.
3. Connect one end of the black battery cable to the
NEGATIVE (-) battery terminal (C) on the charged
battery.
4. Connect the other end of the black battery cable to
a CHASSIS GROUND (D), away from the fuel tank
and the battery.
To remove the jumper cables
Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
1923 - 005 - 13.10.2022
Risk of explosion because
Do not use the battery of
C
D
Do not let the ends of
Cutting deck
To remove and install the cutting deck
Note:
If an accessory other than the cutting deck is
to be used, the front link and the rear lift links must be
removed from the product. Also, the clutch cable spring
must be put into the cable guide on the front edge of the
lower dash.
1. Disengage the cutting deck. Refer to
disengage the cutting deck on page 20 .
2. Stop the product. Refer to
page 19 .
3. Lower the cutting deck to the lowest position.
4. Remove the center chute. Refer to
install the center chute on page 30 .
5. Remove the mandrel cover (A).
B
C
I
H
J
K
6. Remove the clutch cable (B), push the tab (C) and
remove the clutch cable from the bracket.
7. Remove the drive belt from the clutch pulley (D).
8. Carefully remove the clutch cable spring (E) from the
idler arm (F).
9. Disconnect the front link (G) from the cutting deck
and remove the retainer spring and washer.
10. Remove the clips (H) and disconnect the suspension
arms (I) from the chassis pins.
11. Disconnect the rear lift links (J) from the rear cutting
deck brackets (K) on each side of the cutting deck.
12. Remove the cutting deck from the product.
13. Install the cutting deck in the opposite sequence.
Make sure that the grass discharge is on the right
side of the product.
Note:
The suspension arms must be in forward
position before you move the cutting deck below the
product.
To engage and
To stop the product on
To remove and
H
G
D
H
I
F
E
A
29